Here you can input and/or change all the settings for the individual foundation design. When you create a new workspace, the Workspace Settings automatically populate with those set in App Settings. However, you can make any changes necessary for the specific workspace. When you make a change, that value will become highlighted in yellow.
You may also save or load Templates for the entire Workspace or for the Rebar table or Formwork dimension.
Please see the following topics for further information about each settings page
-Reinforced Concrete Design Codes
-Soil
Note: Workspace settings are workspace type specific. For eg Shaft3D and ds-Tank3D workspace settings will be different than the ones required for Foundation3D and Mat3D.